Filter
Top Products
12
12. Start an M8 x 25mm Bolt (5) with an M8 Star
Washer (10) and two 5/16" x 5/8" Screws (113)
with two M8 Star Washers (10) into the Right
Upright (89) and Right Handrail (101) as shown.
Do not tighten the Bolt and Screws yet.
Attach the Left Handrail (not shown) as de-
scribed above. Then, tighten both Bolts and
all four Screws.
113
12
10
10
89
101
5
11. Have a second person hold the console assem-
bly near the Right Upright (89).
C
onnect the Upright Wire (88) to the console
wire. See the inset drawing. The connectors
s
hould slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the
Upright Wire. Then, insert the connectors into
the Right Upright (89).
Set the console assembly on the Right Upright
(89) and the Left Upright (not shown). Make sure
that no wires are pinched.
89
Console
Assembly
Console Wire
Wire
Tie
88
11
88
Console
Wire