Filter
Top Products
Owner’s Manual: Maintenance 69
4. If needed, enter the safety code by pressing the following
number keys in sequence: 1, 2, 3, 4.
The running belt starts automatically after a 3-second
countdown appears on the display.
5. Press the SPEED ▲ key until the display shows a speed
of 3 mph (5 kph).
CAUTION: If you hear any chafing or the running belt
appears to be getting damaged, stop the running belt
immediately by pressing the red STOP button.
Contact Precor Customer Support.
6. Walk around to the rear of the unit and observe the belt
for a few minutes. The belt should be centered on the
running belt. If the belt drifts off center, you must make
adjustments. Refer to Adjusting the Running Belt.
Important: Failure to align the belt may cause the belt to
tear or fray, which is not covered by the Precor Limited
Warranty.
7. To stop the running belt, press the red STOP button.
8. Turn the treadmill Off.
Adjusting the Running Belt
If you are unsure about adjusting the running belt, call Precor
Customer Support. Refer to Obtaining Service.
CAUTION: For your safety, use the I/O power switch to turn
Off the treadmill before making any adjustments. Do not
adjust the running belt when someone is standing on the
unit.
1. Locate the right belt adjustment bolt in the rear end
cap of the treadmill. Refer to Diagram 13.
Diagram 13: Location of the adjustment bolt
To determine left and right, stand at the rear of the
treadmill and face the display. Make all belt adjustments
on the right rear corner bolt using the hex key provided.