Filter
Top Products
Owner’s Manual: Advanced Programming and Troubleshooting 62
Informational Displays
The treadmill provides information about its use (odometer
and hour meter), as well as software version, serial number,
usage log, and error codes. In general, you would only
access this information if directed to do so by Precor
Customer Support.
These instructions guide you through all eight informational
displays. Pressing the OK key moves you through the
displays. Pressing the navigational arrow keys cycles you
through the menu selection. To exit, press PAUSE/RESET at
any time.
Important: Quick access to the informational displays is
available if error messages have appeared on the display
and have been recorded in the error log. This feature is
usually reserved for service personnel. At the Precor
banner, press and hold PAUSE/RESET or STOP for 4
seconds. If DIAGS - INFORMATION DISPLAY appears
continue with step 2. If no errors are logged, STUCK KEY or
STOP KEY appears. When you release the key, the Precor
banner returns.
Viewing the Odometer
1. At the Precor banner, press the following keys in
sequence and without pause:
PAUSE/RESET, 6, 5
The numbers 6, 5 appear on the display as you press the
associated key.
Then DIAGS - INFORMATION DISPLAY scrolls across
the display followed by ODOMETER.
2. Press OK to view the odometer value (cumulative miles
traveled) or press the ▼ arrow key to move to the next
informational display.
Note: If the unit of measure is set to metric, then
kilometers appears instead of miles.
3. When you are ready, press OK to move to the next
display (hour meter).