Filter
Top Products
Product Owner’s Manual: Club Features 8
Club Features
These next few pages provide information that lets you customize
the cycle for your club. All these features remain hidden to the club
patrons and can only be accessed using special key presses. Read
this section if you want to:
• Change the display to a different language
• Change the display to U.S. Standard or Metric
• Set the maximum workout and pause times
• Set a cool-down time limit
• Customize a program
• View the odometer
• Display the number of hours the cycle has been in use
• View the software versions and part numbers
• Check the error log
• Display the serial number
• Connect to CSAFE equipment
Club Programming Tips
• Electrical power must be supplied. A minimum pedal speed (20
revolutions per minute) must be maintained while programming
the cycle. A constant power source is available if you use the
optional power adapter. If you plan to program the cycle,
purchasing the optional power adapter is highly recommended.
Note: If you do not use the optional power adapter during club
programming mode, and the pedal speed falls below 20 RPM, no
warning is given when the cycle moves into its 30-second
shutdown procedure.
• The club programming mode is accessed by pressing the RESET
key at the Precor banner. The remaining key presses must occur
quickly and without pause. Always start at the Precor banner.
• The function of the QUICKSTART key is disabled while in club
programming mode.
• The club programs appear sequentially. Pressing the ENTER key
on the C846i or the SELECT on the C842i saves the changes
you make and moves you through the programs. To exit a program
without saving any changes, press the RESET key.