Polar RC3 GPS Cyclometer User Manual


 
Keep your training computer and sensors in a cool and dry place. Do not keep them in a damp
environment, in non-breathable material (a plastic bag or a sports bag) nor with conductive material (a wet
towel). Do not expose the training computer to direct sunlight for extended periods, such as by leaving it
in a car or mounted on the bike mount.
It is recommended to store the training computer partially or fully charged. The battery slowly loses its
charge when it is stored. If you are going to store the training computer for several months, it is
recommended to recharge it after a few months. This will prolong the battery lifetime.
Dry and store the strap and the connector separately to maximize the heart rate sensor battery lifetime.
Keep the heart rate sensor in a cool and dry place. To prevent snap oxidation, do not store the heart rate
sensor wet in non-breathing material, such as a sports bag. Do not expose the heart rate sensor to direct
sunlight for extended periods.
Service
During the two-year guarantee/warranty period we recommend that you have service done by an authorized
Polar Service Center only. The warranty does not cover damage or consequential damage caused by service
not authorized by Polar Electro. For further information, see Limited International Polar Guarantee
(page ? ).
For contact information and all Polar Service Center addresses, visit www.polar.com/support
[http://www.polar.com/support] and country-specific websites.
Register your Polar product at http://register.polar.fi/ to ensure we can keep improving our products and
services to better meet your needs.
The username for your Polar Account is always your email address. The same username and password are valid for
Polar product registration, polarpersonaltrainer.com, Polar discussion forum and newsletter registration.
Batteries
The Polar RC3 GPS training computer has an internal, rechargable battery. Rechargeable batteries have a
limited number of charge cycles. You can charge and discharge the battery over 300 times before a
notable decrease in its capacity. The number of charge cycles also varies according to use and operating
conditions.
At the end of the working life of the product Polar encourages you to minimize possible effects of waste on
the environment and human health by following local waste disposal regulations and, where possible,
utilizing separate collection of electronic devices. Do not dispose of this product as unsorted municipal
waste.
The Polar H2/H3 heart rate sensor has a user changeable battery. To change the battery yourself, please
follow the instructions carefully as instructed in chapter Change the Heart Rate Sensor Battery.
The batteries for the CS speed sensor W.I.N.D. and CS cadence sensor W.I.N.D. cannot be replaced. Polar
has designed the sensors to be sealed in order to maximise mechanical longevity and reliability. The
sensors have long-life batteries inside. To purchase a new sensor contact your authorized Polar Service
Center or retailer.
For battery information of the Polar s3+ stride sensor, consult the user manual for the product in question.
Keep the batteries away from children. If swallowed, contact a doctor immediately. Batteries should be disposed of
properly according to local regulations.
Change the Heart Rate Sensor Battery
To change the battery of the heart rate sensor yourself, carefully follow the instructions below:
When changing the battery, make sure the sealing ring is not damaged, in which case you should replace
it with a new one. You can purchase the sealing ring/battery kits at well-equipped Polar retailers and
authorized Polar Services. In the USA and Canada, the additional sealing rings are available at authorized
ENGLISH
Important Information 51