Filter
Top Products
5. TRAINING
Wearing the Heart Rate Sensor
Wear the heart rate sensor to measure heart rate.
1. Moisten the electrode area of the
strap.
2. Attach the connector to the strap.
3. Tie the strap around your chest,
just below the chest muscles, and
attach the hook to the other end of
the strap.
4. Adjust the strap length to fit tightly
but comfortably. Check that the
moist electrode areas are firmly
against your skin and that the Polar
logo of the connector is in a central
and upright position.
Detach the connector from the strap
after every use, to maximize the
battery lifetime. Sweat and moisture
may keep the electrodes wet and the
heart rate sensor activated. This will
reduce the battery life. For more
detailed washing instructions, see
Important Information
(page ? ).
For video tutorials, go to http://www.polar.com/en/polar_community/videos.
Starting a Training Session
Wear the heart rate sensor and make sure you have set up an optional sensor* as instructed in the sensor's
user manual. If you are using a speed, cadence, or stride sensor for the first time, see New Accessory
(page 38). To use Polar ZoneOptimizer feature for your training session, see Train with Polar ZoneOptimizer
(page 16).
1. Start by pressing START
1. In time view, press START to enter the pre-training mode.
2. Pair the heart rate sensor with the training computer
(pairing is performed only once)
Pairing ensures that your training computer receives signal from your heart rate sensor only and enables
interference-free training when there are other training computers around.
If you purchased a set which does not include a heart rate sensor, and you have set the heart
rate sensor off in the Sport Profile settings, skip step two and go straight to step three.
ENGLISH
Training 13