9. Place the bracket on the lower end of the Weight
Upright (2) over the indicated 3/8Ó x 2 3/4Ó Carriage
Bolts (45) in the Weight Base (5). Hand tighten two
3/8Ó Nylon Locknuts (50) onto the Bolts. Do not tight-
en the Nylon Locknuts yet.
Locate two 3/8Ó x 1 3/4Ó Bolts (57) and slide a 3/8Ó
Flat Washer (55) onto each of them. Insert the Bolts
through the indicated holes in the Weight Upright (2)
and then through the bracket on the Support Upright
(3). Secure the Bolts with two 3/8Ó Nylon Locknuts
(50).
Go back and fully tighten all Nylon Locknuts used
in steps 2 through 9.
9
7
7. Locate two 3/8Ó x 4 3/4Ó Bolts (46) and slide a 3/8Ó
Flat Washer (55) onto each of them. Insert the Bolts
through the indicated holes in the Top Frame (9) and
then through the holes in the Main Upright (1). Slide a
3/8Ó Flat Washer onto each Bolt and secure it with a
3/8Ó Nylon Locknut (50). Do not tighten the Nylon
Locknut yet.
7
8. Slide a 3/8Ó Flat Washer (55) onto a 3/8Ó x 4 3/4Ó Bolt
(46) and push the Bolt through the Top Frame (9).
Push the Bolt into the hole in the Support Upright (3)
until the tip of the Bolt is visible inside the Upright.
Slide the 1/2Ó x 1 13/16Ó Bushing (84) down into the
Upright and push the Bolt all the way through the
Bushing and the Upright. Note: Make sure you donÕt
drop the Bushing into the Upright!
Slide a 3/8Ó Flat Washer (55) onto the Bolt and
secure it with a 3/8Ó Nylon Locknut (50). Do not
tighten the Nylon Locknut yet.
Slide a 3/8Ó Flat Washer (55) onto a 3/8Ó x 2 3/4Ó Bolt
(47) and insert the Bolt through the hole in the
Support Upright (3) and the bracket on the Top Frame
(9). Hand tighten a 3/8Ó Nylon Locknut (50) onto the
Bolt. Do not tighten the Nylon Locknut yet.
8
45
5
50
3
50
50
55
2
50
57
55
50
Bracket
Bracket
1
9
55
46
28
9
50
55
55
1
55
47
3
84
50
46