Filter
Top Products
12
26. Route the end of the High Cable (73) with the loop
through the bracket on the Main Upright (1) from
above. Route the High Cable over a 3 1/2Ó Pulley (24)
in the direction shown.
Slide the 3 1/2Ó Pulley (24) into the bracket on the
Main Upright (1). Slide a 3/8Ó x 3Ó Bolt (53) through
the bracket and the Pulley, but do not mount a
Locknut yet.
26
1
73
53
24
Bracket
27. Locate the Adjustable Pulley Frame (23) and remove
the 3 1/2Ó Pulleys (24) and Cable Traps (25).
Wrap the High Cable (73) around a 3 1/2Ó Pulley (24)
in the direction shown. Attach the 3 1/2Ó Pulley and a
Cable Trap (25) to the top half of the Adjustable
Pulley Frame (23) with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó
Nylon Locknut (50). Note: The Pulley must be
attached to the upper of the three adjustment
holes. Make sure the Cable Trap is oriented as
shown.
Route the end of the High Cable (73) with the loop
through the bracket on the Main Upright (1) from
below.
27
23
50
25
1
54
24
73
25. Identify the High Cable (73). It is approximately
340Ó long and it has a ball on one end and a loop
on the other.
Route the end of the High Cable (73) with the loop
through the slot in the Main Upright (1).
Wrap the end of the High Cable (73) with the ball
around a 3 1/2Ó Pulley (24) as shown.
Attach the 3 1/2Ó Pulley (24) inside the slot in the
Main Upright (1) with a 3/8Ó x 3 3/4Ó Bolt (59), two
3/8Ó Flat Washers (55), two 5/8Ó x 1Ó Bushings (86)
and a 3/8Ó Nylon Locknut (50).
25
50
55
55
1
Slot
86
59
24
73
86
24. Thread the bolt at the end of the Low Cable (72) a
couple of turns into the Weight Tube (17).
24
72
Bolt
17
Bracket