Filter
Top Products
14
33. Wrap the High Cable (73) around a 3 1/2Ó Pulley (24)
in the direction shown.
Attach the 3 1/2Ó Pulley (24) and a Cable Trap (25) to
the riser on the Weight Base (5) by sliding the Cable
Trap and Pulley onto the 3/8Ó x 4 3/4Ó Bolt (46)
attached in step 31. Thread a 3/8Ó Nylon Locknut (50)
onto the Bolt and tighten it. Make sure the Cable
Traps for both of the Pulleys attached to the riser
are oriented as shown in this step and in step 31.
Note: For the sake of clarity, drawing 33A shows
some parts removed.
34. Wrap the High Cable (73) around a 3 1/2Ó Pulley (24)
in the direction shown.
Attach the 3 1/2Ó Pulley (24) and a Cable Trap (25) to
the sidearm on the Weight Base (5) by sliding the
Pulley and Cable Trap onto the 3/8Ó x 3 1/2Ó Carriage
Bolt (62) inserted earlier. Tighten a 3/8Ó Nylon Jamnut
(63) onto the Bolt. Make sure the Cable Trap is ori-
ented as shown.
33A B
34
32. Wrap the High Cable (73) around a 3 1/2Ó Pulley (24)
in the direction shown.
Attach the 3 1/2Ó Pulley (24) to the lower half of the
Small Pulley Frame (22) with a 3/8Ó x 2Ó Bolt (54) and
a 3/8Ó Nylon Locknut (50).
32
50
54
24
73
Mount
Pulley
Here
50
46
62
5
73
25
24
63
22
24
25
Riser
5
35. Wrap the High Cable (73) around a 3 1/2Ó Pulley (24)
in the direction shown.
Attach the 3 1/2Ó Pulley (24) and a Cable Trap (25) to
the welded tube on the Seat Base (6) by sliding the
Pulley and Cable Trap onto the 3/8Ó x 3 1/2Ó Bolt (56)
inserted earlier. Thread a 3/8Ó Nylon Locknut (50)
onto the Bolt and tighten it. Make sure the Cable
Trap is oriented as shown.
Note: For the sake of clarity, drawing 35A shows
some parts removed.
73
35A B
73
Mount
Pulley
Here
50
56
24
25
Welded
Tube
6