Filter
Top Products
4. Place the bracket on the lower end of the Main
Upright (1) over the indicated 3/8Ó x 2 3/4Ó Carriage
Bolts (45) in the Stabilizer (4). Hand tighten two 3/8Ó
Nylon Locknuts (50) onto the Bolts. Do not tighten
the Nylon Locknuts yet.
Insert two 3/8Ó x 3Ó Bolts (53) with two 3/8Ó Flat
Washers (55) through the indicated holes in the
Stabilizer (4) and the bracket on the Main Upright (1).
4
6
5. Press a 2Ó Square Inner Cap (28) into the end of the
Seat Base (6).
Insert two 3/8Ó x 2 3/4Ó Carriage Bolts (45) up through
the indicated holes in the Seat Base (6) and secure
the bolt heads with pieces of tape to prevent them
from falling out.
Insert a 3/8Ó x 3 1/2Ó Bolt (56) up through the welded
tube on the Seat Base (6) and secure the bolt head
with tape.
Place the Seat Base (6) on the floor with the holes in
the mounting bracket over the 3/8Ó x 3Ó Bolts (53)
going through the Stabilizer (4) and the bracket on
the Main Upright (1). Hand tighten two 3/8Ó Nylon
Locknuts (50) onto the Bolts. Do not tighten the
Nylon Locknuts yet.
5
50
53
55
50
53
55
4
1
1
4
45
2845
56
6
53
50
6. Place the Seat Frame (7) onto the 3/8Ó x 2 3/4Ó
Carriage Bolts (45) in the Seat Base (6). Hand tighten
two 3/8Ó Nylon Locknuts (50) onto the Bolts. Do not
tighten the Nylon Locknuts yet.
Locate two 3/8Ó x 3Ó Bolts (53) and slide a 3/8Ó Flat
Washer (55) onto each Bolt. Insert the 3/8Ó x 3Ó Bolts
through the indicated holes in the Main Upright (1)
and the bracket on the Seat Frame (7). Hand tighten
two 3/8Ó Nylon Locknuts (50) onto the Bolts. Do not
tighten the Nylon Locknuts yet.
6
45
6
50
55
50
7
50
Welded Tube
53
1