Filter
Top Products
17
17. Leg Lever Assembly. Attach a Bumper (40) to the
Seat Frame (7) with a #8 x 1Ó Screw (78).
Press a 2Ó Square Inner Cap (28) into the indicated
end of the Leg Lever (41).
Lubricate a 3/8Ó x 3Ó Bolt (53). Attach the Leg Lever
(41) to the Seat Frame (7) with the 3/8Ó x 3Ó Bolt and
a 3/8Ó Nylon Jamnut (63).
10
18. Locate and open the parts bag labeled ÒCable
Assembly and Pulleys.Ó For Cable identification
and routing during steps 18Ñ39, refer to the
Cable Diagram and Cable ID Chart on page 19.
Identify the Low Cable (72). It is approximately
176Ó long and it has a ball on one end and a bolt
on the other.
Route the end of the Low Cable (72) with the ball
through the bracket on the Weight Base (5) as
shown. Attach the 3 1/2Ó Pulley (24) to the bracket
with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut
(50).
18
40
78
53
7
Lubricate
41
28
63
24
72
50
54
Cable Assembly
5
Bracket
19. Wrap the Low Cable (72) around a 3 1/2Ó Pulley (24)
in the direction shown.
Attach the 3 1/2Ó Pulley (24) and a Cable Trap (25) to
the welded tube on the Weight Upright (2) with a 3/8Ó
x 3 3/4Ó Bolt (59) and a 3/8Ó Nylon Locknut (50).
Make sure the Cable Trap is oriented as shown.
19
2
59
72
50
25
24
Welded
Tube