Filter
Top Products
11
23. Feed the end of the Low Cable (72) through the indi-
cated slot in the Weight Upright (2) from above.
Wrap the Low Cable (72) around a 3 1/2Ó Pulley (24).
Attach the 3 1/2Ó Pulley inside the slot in the Weight
Upright (2) with a 3/8Ó x 2 3/4Ó Bolt (47), two 3/8Ó Flat
Washers (55), two 5/8Ó x 1/2Ó Bushings (85) and a
3/8Ó Nylon Locknut (50). Make sure the Low Cable
is wrapped around the Pulley in the direction
shown, and that it is between the welded rod
inside the Upright and the Pulley.
23
22. Feed the bolt at the end of the Low Cable (72)
through the indicated slot in the Weight Upright (2)
from below.
Attach a 3 1/2Ó Pulley (24) inside the slot in the
Weight Upright (2). To do this, slide a 3/8Ó Flat
Washer (55) and a 5/8Ó x 1/2Ó Bushing (85) onto a
3/8Ó x 2 3/4Ó Bolt (47). Insert the Pulley into the slot in
the Upright and hold it in position while pushing the
Bolt through the hole in the Upright and the Pulley.
Slide a 5/8Ó x 1/2Ó Bushing (85) and a 3/8Ó Flat
Washer (55) onto the Bolt and secure it with a 3/8Ó
Nylon Locknut (50). Make sure the Low Cable (72)
is wrapped around the Pulley in the direction
shown, and that it is between the welded rod
inside the Upright and the Pulley.
22
21. Route the Low Cable (72) through the indicated slot
in the Support Upright (3) from above.
Locate the Small Pulley Frame (22) and remove both
of the pre-assembled 3 1/2Ó Pulleys (24).
Wrap the Low Cable (72) around a 3 1/2Ó Pulley (24)
in the direction shown. Attach the 3 1/2Ó Pulley (24) to
the top half of the Small Pulley Frame (22) with a 3/8Ó
x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut (50). Note:
The Pulley Frame must be oriented as shown.
Route the Low Cable (72) through the indicated slot
in the Support Upright (3) from below.
21
24
54
72
3
22
Route Cable
Through Slot
From Below
50
47
2
24
85
55
50
72
Bolt
20. Wrap the Low Cable (72) around a 3 1/2Ó Pulley (24)
in the direction shown.
Attach the 3 1/2Ó Pulley (24) and a Cable Trap (25) to
the bracket on the Press Adjustment Frame (14) with
a 3/8Ó x 3Ó Bolt (53), a 3/8Ó Flat Washer (55), a 5/8Ó x
1 1/4Ó Bushing (91) and a 3/8Ó Nylon Jamnut (63).
Make sure the Cable Trap is oriented as shown.
20
14
24
91
25
63
53
55
72
55
85
47
2
24
85
55
50
72
Bolt
55
85
Route Cable
Through Slot
From Above
Welded Rod
Welded Rod