Filter
Top Products
1. Before beginning, make sure that you have read
and understood the information on page 4.
Locate and open the parts bag labeled ÒFRAME
ASSEMBLY.Ó
Insert four 3/8Ó x 2 3/4Ó Carriage Bolts (45) up
through the indicated holes in the Stabilizer (4). Insert
a 3/8Ó x 3 1/2Ó Carriage Bolt (62) up through the hole
in the sidearm on the Stabilizer. Note: If the Bolts
tend to fall out, secure them by putting a small
piece of tape over the head of each Bolt. Place the
Stabilizer flat on the floor.
1
2. Place the bracket on the lower end of the Support
Upright (3) over the indicated 3/8Ó x 2 3/4Ó Carriage
Bolts (45) in the Stabilizer (4). Hand tighten two 3/8Ó
Nylon Locknuts (50) onto the Bolts. Do not tighten
the Nylon Locknuts yet.
CAUTION: Until step 3 has been performed, the
unit can easily tip over. Have one person hold the
Support Upright in position or lean it against a
wall.
Insert two 3/8Ó x 3Ó Bolts (53) with two 3/8Ó Flat
Washers (55) through the indicated holes in the
Stabilizer (4) and the bracket on the Support Upright
(3).
3. Press a 2Ó Square Inner Cap (28) into the end of the
Weight Base (5).
Press a 2Ó Square Inner Cap (28) into the end of the
riser on the Weight Base (5).
Press a 2Ó Square Cover Cap (33) onto the sidearm
on the Weight Base (5).
Insert two 3/8Ó x 2 3/4Ó Carriage Bolts (45) up through
the indicated holes in the Weight Base (5) and secure
the bolt heads with pieces of tape to prevent them
from falling out.
Insert a 3/8Ó x 3 1/2Ó Carriage Bolt (62) up through
the hole in the sidearm on the Weight Base (5) and
secure the bolt head with tape.
Place the Weight Base (5) on the floor with the holes
in the mounting bracket over the 3/8Ó x 3Ó Bolts (53)
going through the Stabilizer (4) and the bracket on
the Support Upright (3). Hand tighten two 3/8Ó Nylon
Locknuts (50) onto the Bolts. Do not tighten the
Nylon Locknuts yet.
2
3
5
Frame Assembly
45
4
62
45
53
55
45
4
53
55
Bracket
3
50
50
5
45
3
50
28
53
28
62
33
4