Filter
Top Products
Instruction Manual
748297-E
June 2003
Rosemount Analytical Inc. A Division of Emerson Process Management Maintenance and Troubleshooting 4-15
Model NGA2000 HFID
Case Temperature Sensor
1. Per Section 4-2e on page 4-13, re-
move securing hardware from elec-
tronics assembly and lay on bench.
2. Disconnect case temperature sensor
cable.
3. Remove screw securing cable clamp
holder to signal board.
4. Remove case temperature sensor
from cable clamp holder.
5. Per Figure 4-13 below insert re-
placement case temperature sensor
into cable clamp holder.
Re-assemble to signal board mounting
screw.
Figure 4-13. Case Temperature Sensor Installation
Center
sensor in
cable clamp