Filter
Top Products
16
Be careful to assemble all components
in the sequence they are presented.
STEP
mm
Inch
40
SEE NOTE 1 ON PAGE 41:
A. Apply weight stack numbers to weight stack Top Plate (29) and each Weight Stack Plate (87)
as shown.
SEE NOTE 2 ON PAGE 41:
B. Front Shroud (DA) is pre-assembled with Shroud Insert (DB).
Attach Fr
ont Shr
oud (DA) to the side of the weight stack as shown.
Bolt onto Main Base Frame (A) at the bottom and Top Weight Stack Frame (R) using:
Two 108 (3/8” x 5/8” round allen head)
T
wo 70 (3/8” washer)
C.
Attach Back Shroud (DC), to the back side of the weight stack, onto the Main Base Frame (A) at
the bottom and to the T
op W
eight Stack Frame (R) as shown using:
Two 108 (3/8” x 5/8” round allen head)
Two 70 (3/8” washer)
D.
Attach Press Arm Shroud (DD) to the Press Arm Support (X) using:
Four 109 (1/8” x 3/8” screw)
E. Connect the Water Bottle Bracket (44) to the Weight Stack Shroud (DA) using:
Two 137 (1/8” washer)
T
wo 109 (1/8” x 3/8” scr
ew)
F. Slide the Water Bottle Holder (43) onto the Water Bottle Bracket (44) as shown.