Filter
Top Products
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
3
14
STEP
A. Attach Multi Hip Base (N) to Main Base Frame (A) using:
Two 54 (3/8” x 2 3/4” hex head bolt)*
Four 70 (3/8” washer)
Two 67 (3/8” nylon lock nut)
*Y
ou must wrench tighten these two bolts (54) now.
B. Attach Multi Hip Vertical Frame (P) and Flat Plate (J) to Multi Hip Base (N) using:
Two 55 (3/8” x 3” hex head bolt)
Four 70 (3/8” washer)
Two 67 (3/8” nylon lock nut)
C.
For more stability secure Multi Hip Vertical Frame (P) to Multi Hip Base (N) connection as shown
with:
One 55 (3/8” x 3” hex head bolt)
T
wo 70 (3/8” washer)
One 67 (3/8” nylon lock nut)
D.
Attach Multi Hip Vertical Frame (P) and Rear Base Frame (B) using:
One 54 (3/8” x 2 3/4” hex head bolt)*
One 70 (3/8” washer)
*NOTE
This bolt (54) goes into inter
nal thr
eads inside Rear Base Frame (B).
E. Insert two Foot Caps (11) into the ends of Multi Hip Vertical Frame (P).
Attach End Cap (17) to the top of Multi Hip V
er
tical Frame (P).
Attach Round End Cap (22) to the end of the handles on Multi Hip Vertical Frame (P) as shown.
NOTE:
Finger tighten all har
dwar
e in this step, except where noted* in part A. Do Not
wrench
tighten any other hardware until the end of step 4.