A SERVICE OF

logo

1 - 10
1 Installation
MITSUBISHI CNC
(4) Do not use the unit with the cable submerged in oil or water.
(Refer to following drawing.)
(5) Make sure that oil and water do not flow along the cable into the motor or encoder.
(Refer to right drawing.)
(6) When installing on the top of the shaft end, make sure that oil from the gear box, etc., does not enter the servo motor.
The servo motor does not have a waterproof structure.
1.1.9 Installation of Servo Motor
Mount the servo motor on a flange which has the following size or produces an equivalent or higher heat dissipation
effect:
Flange size (mm) Servo motor capacity
150×150×6 100W
250×250×6 200 to 400W
250×250×12 0.5 to 1.5kW
300×300×20 2.0 to 7.0kW
800×800×35 9.0 to 11.0kW
Cover
Oil water
<Fault> Capillary tube phenomenon
Servo motor
<Fault> Respiration
Cover
Servo motor
Servo motor
Gear
Lubricating oil