4 - 122
【#3135】 sfwd_g Feed forward gain for hobbing axis
Set the feed forward gain for the hobbing axis in tool spindle synchronization II (hobbing) mode.
---Setting range---
0 to 200 (%)
【#3137】 stap_ax_off High-speed synchronous tapping unsupported axis
Not used. Set to "0".
【#3138】 motor_type Spindle motor type
Set the spindle motor type. The set type will be displayed on the drive
monitor screen, and it will be also output to the system configuration data.
---Setting range---
Character string within 26 characters including A-Z, a-z, 0-9, "." (decimal point), "-" (hyphen), "/"
(slash)
(Cleared by inputting "0".)
【#3140(PR)】 S_DINSp Speed observation input door No.
Set the door signal input in the drive unit.
Use this parameter only when the axis with a door signal belongs to several door groups.
The correspondence between the door signals and bits are as follows.
bit0 : Door1 signal
bit1 : Door2 signal
If the axis does not receive any door signal, set to "0".
An error (Y20 0027) will occur in the following cases.
- Several bits are enabled.
- Any bit other than those set in "#3071 S_DSlSp" is enabled.
---Setting range---
0000 to 0002 (HEX)
