Mitel sx-200 Manual

A SERVICE OF

next previous

38

SX-200 ICP MX Technician’s Handbook

Removing the cover

To remove the SX-200 ICP Controller cover:

1. Unplug the power cord from the controller and disconnect all cables.

2. Remove the controller from the rack or wall and place it on a suitable

work area (if applicable).

3. Remove the four screws from the top of the controller.

4. Slide the cover forward until it catches, then tilt the cover upward to

remove it.

5. Remove the front faceplate by clipping it off from the bottom of the unit.

.

Note: It may be easier to pry the end off first, and then slide your fingers along

the bottom edge of the faceplate to the other end.