A SERVICE OF

logo

200
SX-200 ICP MX Technician’s Handbook
6. Replace the cover.
7. Restore power to the controller.
8. Perform an Initial (CompactFlash Card) installation from the software
CD; see page 35 for instructions.
Replacing the Analog Main Board
1. Unplug the power cord from the controller.
2. Remove the top cover.
3. Remove the front panel.
4. Disconnect the three power supply connectors.
5. Remove the ribbon cable by flipping up the clip on the connectors at
each end of the cable as shown in the following figure.
Note: When prompted for a database, select Custom to install a backup of
the original database (if available).