ELECTRICAL SYSTEM 16-73
Meter, Gauge, Indicator Unit
•
If the oscillator is not available, the speedometer can be
checked as follows.
○
Install the meter unit.
○
Raise the rear wheel off the ground, using the jack.
○
Turn on the ignition switch.
○
Rotate the rear wheel by hand.
○
Check that the speedometer shows the speed.
If the speedometer does not work, check the speed sen-
sor and wiring (see Speed Sensor section in the Fuel Sys-
tem (DFI) chapter).
If the speed sensor and wiring are normal, replace the
meter assembly.
Odometer Check
•
Check the odometer with the speedometer check in the
same way.
If value indicated in the odometer is not added, replace
the meter assembly.
NOTE
○
The data is maintained even if the battery is discon-
nected.
○
When the figures come to 999999, they are stopped and
locked.
Trip Meter Check
•
Check the trip meter with the speedometer in the s ame
way.
If value indicated in the trip meter is not added, replace
the meter assembly.
•
Check that when the RESET button is pushed for more
than two seconds, the figure display turns to 0.0.
If the figure display does not indicate 0.0, replace the me-
ter assembly.
Water Temperature Meter Check
•
Connect the 12 V battery and terminals in the same man-
ner as specified in the "Liquid Crystal Display (LCD) Seg-
ments Check".
•
Connect the variable rheostat [A] to the terminal [8] as
shown.
•
Check that the number of segments matches the resis-
tance value of the variable rheostat.
Resistance Value
(Ω)
Temperature Meter Warning Indicate
––
-[A]
209.8 50°C (122°F) -[B]
69.1 80°C (176°F) -[B]
21.2 120°C (248°F) Flash [C]
17 HI Flash [D]
•
If any display function does not work, replace the meter
assembly.
