A SERVICE OF

logo

ELECTRICAL SYSTEM 16-55
Electric Starter System
Pull the armature [A] out of the yoke [B].
Remove:
Brush Plate Terminal Nut [A]
Brush Plate Assembly [B]
Starter Motor Assembly
Pry the spring end [A] and insert the brush [B].
Install the brush plate assembly [A] into the right-hand end
cover [B].
Replace the O-ring [C] with a new one.
Install:
Insulators [D]
Washer [E]
Tighten:
Torque - Starter Motor Terminal Locknut [F]: 6.9 N·m (0.70
kgf·m, 61 in·lb)
Install the armature [A] into the yoke [B].
Install the slip [C] and thrust washers [D] onto each side
of the shaft.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com