COOLING SYSTEM 4-21
Hoses and Pipes
Hose Installation
•
Install the hoses and pipes, being careful to follow bend-
ing direction. Avoid sharp bending, kinking, flattening or
twisting.
•
Run the hoses in accordance with the Cable, Wire, and
Hose Routing section in the Appendix chapter.
•
Install the clamp [A] as near as possible to the hose end
to clear the raised rib of the fitting. This will prevent the
hoses from working loose.
○
The clamp screws should be positioned correctly to pre-
vent the clamps from contacting the other parts.
Torque - Water Hose Clamp Screws: 2.0 N·m (0.20 kgf·m,
18 in·lb)
Hose Inspe ction
•
Refer to the Radiator Hose and Connection Inspection
in the Periodic Maintenance chapter (see Radiator Hose
and Connection Inspection in the Periodic Maintenance
chapter).
