5-44 ENGINE TOP END
Muffler
Front Exhaust Pipe Installation
•
Replace the front exhaust pipe gaskets [A] with new ones.
•
Replace the middle exhaust pipe gasket [B] with a new
one.
○
Install the middle exhaust pipe gasket until it is bottomed
so that the chamfer side (inner) faces front exhaust pipe.
•
Install the front exhaust pipe [C].
•
Install the middle exhaust pipe clamp bolt [D] as shown.
Upside [E]
Outside [F]
35° ∼ 55° [G]
Front View [H]
•
Tighten:
Torque - Front Exhaust Pipe Holder Nuts [I]: 17 N·m (1.7
kgf·m, 13 ft·lb)
Middle Exhaust Pipe Clamp Bolt: 17 N·m (1.7
kgf·m, 13 ft·lb)
•
For the Europe Models, Route the oxygen sensor leads
correctly (see Cable, Wire, and Hose Routing section in
the Appendix c hapter).
•
Install the radiator (see Radiator and Radiator Fan Instal-
lation in the Cooling System chapter).
•
Throughly warm up the engine, wait until the engine cools
down, retighten all the bolt and nuts.
