Use the product control panel
Configure the TC/IP settings
You can configure the IP address manually or automatically.
Manual configuration
1. On the control-panel menu, press OK.
2. Use the Left arrow (
) or the Right arrow ( ) button to select Network config., and then press
OK.
3. Use the Left arrow (
) or the Right arrow ( ) button to select TCP IP config, and then press
OK.
4. Use the Left arrow (
) or the Right arrow ( ) button to select Manual, and then press OK.
5. Press the Right arrow (
) button to increase the value for the first section of the IP address. Press
the Left arrow (
) button to decrease the value. When the value is correct, press OK.
6. If the address is correct, use the Left arrow (
) or the Right arrow ( ) button to select Yes, and
then press OK. Repeat step 5 for the subnet mask and default gateway settings.
-or-
If the IP address is incorrect, use the Left arrow (
) or the Right arrow ( ) button to select No,
and then press OK. Repeat step 5 to establish the correct IP address, and then repeat step 5 for
the subnet mask and default gateway settings.
Automatic configuration
NOTE: Automatic is the default Network config. TCP IP config setting.
1. On the control-panel menu, press OK.
2. Use the Left arrow (
) or the Right arrow ( ) button to select Network config., and then press
OK.
3. Use the Left arrow (
) or the Right arrow ( ) button to select TCP IP config, and then press
OK.
4. Use the Left arrow (
) or the Right arrow ( ) button to select Automatic, and then press OK.
It might take several minutes before the automatic IP address is ready for use.
NOTE: To disable or enable specific automatic IP modes (such as BOOTP, DHCP, or AutoIP), use
the embedded Web server or HP ToolboxFX.
ENWW Network configuration 25
