7-19
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter 7 Card Provisioning
Provisioning Optical Cards
Step 4 Click Apply.
Procedure: Provision Threshold Settings for OC-N Cards
Step 1 Display the OC-N card in CTC card view (Figure 7-2 on page 7-19).
Step 2 Click the Provisioning > Thresholds tabs.
Figure 7-2 Provisioning thresholds for the OC48 IR 1310 card
Step 3 Modify the settings shown in Table 7-8 on page 7-20.
Default thresholds apply to all optical cards unless otherwise specified.
Send Do Not
Use
When checked, sends a DUS (do not use) message on
the S1 byte
• Yes (checked)
• No (unchecked; default)
PJ Sts Mon # Sets the STS that will be used for pointer
justification. If set to 0, no STS is monitored. Only
one STS can be monitored on each OC-N port. See
the “Pointer Justification Count Parameters” section
on page 8-12 for more information.
• 0 (default) - 3 (OC-3, per
port)
• 0 (default) - 12 (OC-12)
• 0 (default) - 48 (OC-48)
• 0 (default) - 192 (OC-192)
Status Places port in or out of service
• Out of Service (default
• In Service
Type Defines the port as SONET or SDH. See the
“Provisioning OC-N Cards for SDH” section on
page 7-23.
• Sonet
• SDH
Table 7-7 OC-N Card Line Settings on the Provisioning > Line Tab (continued)
Heading Description Options
