5
31
Repair procedures
Introduction
This section provides instructions for disassembly and reassembly of the monitor.
Required tools and equipment
• 3 in lb torque driver
• 5 in lb torque driver
• #1 Phillips screwdriver bit
• Tweezers
• Needlenose pliers
• Kapton tape
• Soft lens wipes
• Scissors or other cutting device
• Canned air
• Ultrafine-point permanent marker
• Spudger or small paper clip
Caution Perform all repair procedures at a static-protected station.
Caution When the monitor case is opened, all parts must be regarded as
extremely fragile. All procedure steps must be executed with care and precision.