Filter
Top Products
56. Wrap the Press Cable (88) around a “V”
Pulley (81). Attach the “V” Pulley and a Large
Cable Trap (83) to the bracket on the Front
Seat Frame (8) with a 3/8” x 2 1/2” Bolt (65)
and a 3/8” Nylon Locknut (42). Be sure that
the Large Cable Trap is turned to hold the
Cable in place and that the Cable and
Pulley move smoothly.
57. Note: The 3 1/2” Pulley (82) used in this
step was attached in step 55. It is shown
removed for easier part identification.
Route the Press Cable (88) around the 3 1/2”
Pulley (82). Be sure that the Cable Trap (80)
is turned to hold the Cable in place and
that the Cable is routed as shown. Tighten
the 3/8” x 4 1/2” Bolt (74) and the 3/8” Nylon
Jam Nut (43).
58. Slide a 5/16” Washer (20) onto a 5/16” x 2 3/4”
Bolt (55). Insert the Bolt into the Front Seat
Frame (8). Fully tighten a 5/16” Nylon Jam
Nut (91) onto the Bolt. Slide the end of the
Press Cable (88) onto the Bolt. Thread anoth-
er 5/16” Nylon Jam Nut (91) onto the Bolt, but
do not fully tighten it. Leave enough room
between the two Jam Nuts for the Cable to
pivot.
59. Locate and open the parts bag labeled
“SEAT ASSEMBLY.”
Attach the Large Backrest (19) to the Leg
Press Upright (4) with two 1/4” x 2 1/2”
Machine Screws (64) and two 1/4” Washers
(37).
56
57
58
23
CABLE ASSEMBLYSEAT ASSEMBLY
37
4
19
64
59
83
65
81
88
42
8
9
82
43
80
88
91
8
88
20
55
74