Filter
Top Products
14
26. Locate one of the pre-assembled pairs of
Pulley Plates (31) and 3 1/2” Pulleys (82).
Route the Butterfly Cable (85) under the indi-
cated 3 1/2” Pulley (82). The end of the Pulley
Plates (31) with two holes should be down-
ward. Refer to the inset drawing. Be sure
that the Cable is between the Cable Trap
(80) and the Pulley, and that the Cable Trap
is positioned to hold the Cable in place.
Tighten the 3/8” x 2” Bolt (50) and the 3/8”
Nylon Locknut (not shown).
27. Wrap the Butterfly Cable (85) around a 3 1/2”
Pulley (82) as shown. Attach the Pulley and a
Cable Trap (80) to the other side of the bracket
on the Leg Press Upright (4) with a 3/8” x 2”
Bolt (50) and a 3/8” Nylon Locknut (42). The
Cable Trap must be oriented as shown and
be positioned to hold the Cable in the
groove of the Pulley.
28. Note: The Left Arm (6) is shown removed
for easier part identification. Slide the other
end of the Butterfly Cable (85) onto a 3/8” x 1”
Bolt (77). Insert the Bolt through the bracket
on the Left Arm (6). Thread a 3/8” Nylon
Locknut (42) onto the Bolt, but do not fully
tighten it. Leave just enough room for the
Cable to pivot.
CABLE ASSEMBLY
6
End with
two holes
should be
down
82
31
4
42
85
82
50
80
85
89
50
80
77
42
85
28
26
27