Filter
Top Products
48. Note: The 3 1/2” Pulley (82) in this step is
pre-assembled. It is shown dis-assembled
for easier part identification.
Route the Press Cable (88) around the 3 1/2”
Pulley (82) attached to the indicated bracket
on the Press Base (13). Be sure that the
Cable is in the groove of the Pulley and
that the Cable Trap (80) is turned as shown
to hold the Cable in place. Tighten the 3/8”
x 2” Bolt (50) and the 3/8” Nylon Locknut (42).
49. Route the Press Cable (88) over the indicated
3 1/2” Pulley (82) attached to the Pulley
Plates (31). The Cable must be routed from
the direction shown. Refer to the inset draw-
ing. Be sure that the Cable is between the
Cable Trap (80) and the Pulley, and that the
Cable Trap is positioned to hold the Cable
in place.
Tighten the 3/8” x 2” Bolt (50) and the 3/8”
Nylon Locknut (not shown).
50. Wrap the Press Cable (88) around a 3 1/2”
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the Leg Press Upright (4) with a
3/8” x 3 1/2” Bolt (66), a 3/8” Washer (38) and
a 3/8” Nylon Jam Nut (43). Be sure that the
Cable Trap is turned to hold the Cable in
place.
51. Wrap the Press Cable (88) around a 3 1/2”
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the indicated hole in the Press
Frame (12) with a 3/8” x 3 1/2” Bolt (66), a
3/8” Washer (38) and a 3/8” Nylon Locknut
(42). Be sure that the Cable Trap is turned
to hold the Cable in place.
51
48
49
50
21
CABLE ASSEMBLY
50
88
82
80
42
13
31
82
50
88
80
88
82
88
88
12
42
80
38
43
4
80
66
38
66
82