Filter
Top Products
38. Attach the Rear Cable (87) to the Leg Lever
(15) with a 5/16” x 3” Bolt (92), a 5/16”
Washer (20), a 5/8” x 9/16” Bushing (61) and
a 5/16” Nylon Locknut (40).
39. Find the Low Cable (89)—this is the short-
est of the two remaining Cables. Feed the
Low Cable under the 3 1/2” Pro Pulley (97)
and the row tube on the Pulley Base (79).
The ball on the Cable must be on the side
shown. Tighten the 3/8” x 2” Bolt (50) and
3/8” Nylon Locknut (not shown).
40. Wrap the Low Cable (89) around a “V” Pulley
(81). Slide the “V” Pulley and a Large Cable
Trap (83) onto the 3/8” x 4” Carriage Bolt (57)
in the Weight Base (14). Tighten a 3/8” Nylon
Locknut (42) onto the Carriage Bolt.
41. Wrap the Low Cable (89) around a 3 1/2”
Pulley (82). Attach the Pulley to the bracket
on the Weight Base (14) with a 3/8” x 2” Bolt
(50) and a 3/8” Nylon Locknut (42).
41
38
39
40
18
CABLE ASSEMBLY
87
92
40
61
15
20
89
89
97
Row Tube
50
79
Ball
14
57
83
81
42
89
50
14
42
82