Filter
Top Products
11
17. Attach a Press Arm (7) to one side of the
Press Frame (12) with two 5/16” x 2 1/2” Bolts
(39) and two 5/16” Nylon Locknuts (40).
Attach the other Press Arm (7) to the Press
Frame (12) in the same manner.
18. Press a 1” Round Inner Cap (70) into one of
the Press Arms (7). Press a 1 3/4” Square
Inner Cap (48) into the Press Arm.
Repeat this step for the other Press Arm (not
shown).
19. Lubricate both axles on the Butterfly Frame
(3).
Refer to the drawing and identify the Right
Arm (5) and the Left Arm (6).
Press a 1 3/4” Square Inner Cap (48) into the
upper end of the Left Arm (6). Slide the Left
Arm onto the indicated axle. Note: Be careful
not to confuse the Left Arm with the Right
Arm (5). Be sure that the upper end of the
Left Arm is behind the indicated bracket
on the Butterfly Frame (3).
IMPORTANT NOTE: Before assembling the
1” Retainers (45) used in this step, be sure
that you thoroughly understand the step.
The Retainers can be assembled only once.
If they must be removed, you will need to
order new Retainers.
Tap two 1” Retainers (45) and a 1” Round
Outer Cap (46) onto the axle. Be sure that
the teeth on the Retainers bend toward the
Round Outer Cap, as shown in the inset
drawing.
Attach the Right Arm (5) in the same manner.
ARM ASSEMBLY
39
7
70
40
48
12
7
7
3
Lubricate Axle
Axle
6
5
45
48
46
Bracket
45
46
17
18
19