Filter
Top Products
23
Auto Split
Setting Group Adjustment
Auto Split Select DISTANCE to automatically take a split when you reach a multiple of the
selected distance. Select BY TIME to automatically take a split each time the
selected time interval elapses. Select OFF to disable auto split.
Distance Enter the distance at which to automatically take a split. Press 8 to close the
setting change window. The minimum is 0.10. The maximum is 99.99. NOTE: This
setting is only available if the Auto Split setting is set to DISTANCE.
Time Enter the elapsed time at which to automatically take a split. Press 8 to close the
setting change window. The minimum is 00:00:01. The maximum time is 9:59:59.
NOTE: Time settings are only available if the Auto Split setting is set to BY TIME.
Alerts
Use the Alerts menu to set up visual and audible alerts in response to several conditions, including speed and
heart rate.
You can set minimum and maximum values for speed, heart rate, cadence, and power. These values define the
target zone for the setting. If the watch detects
a value outside of this zone, the alert is triggered.
To Configure Alert Type (Visual Only or Visual and Audible)
1. Press MODE until CONFIGURE displays.
2. Press q to highlight ALERTS, then press 8 .
3. Press q to highlight TYPE, then press 8 . Select VISUAL ONLY or AUDIBLE AND VISUAL
4. Press 8 to confirm your selection.
The audible alert tone will sound once every 30 seconds for as long as the reading is outside the target zone.
The visual alert will display a message on top of the display for 2 seconds. It will indicate which data (speed,
heart rate, cadence, or power) is outside the target zone, and whether the reading is low or high.
If more than one reading is outside its target zone, each reading will be listed in the same alert message.
The alert message will display once every 30 seconds for as long as the reading is outside the target zone.
To Configure Alerts Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight ALERTS, then press 8 .
3. Press q to highlight a submenu, then press 8 . The selected configure screen opens.
4. Press p or q to highlight the setting to change, then press 8 to open the setting change window.
5. Press p or q to highlight a selection in the setting change window, then press 8 to confirm your selection.