Filter
Top Products
42
mode (RGB50). See Table 3.6. To advise the diver that attenuated RGBM
has been set, the Diver Attention Symbol is constantly displayed (Table
3.3.)
TABLE 3.6. RGBM MODEL SETTINGS
3.9. ERROR CONDITIONS
The dive computer has warning indicators that alert the user to react
to certain situations that would signifi cantly increase the risk of DCI.
If you do not respond to its warnings, the dive computer will enter an
Error Mode, indicating that the risk of DCI has greatly increased. If you
understand and operate the dive computer sensibly, it is very unlikely
you will ever put the instrument into the Error Mode.
OMITTED DECOMPRESSION
The Error Mode results from omitted decompression, i.e. when you stay
above the ceiling for more than three minutes. During this three-minute
period the Er warning is shown and the audible alarm beeps. After this,
the dive computer will enter a permanent Error Mode. The instrument
will continue to function normally if you descend below the ceiling within
this three-minute period.
Once in the permanent Error Mode only the ER warning is shown in
the center window. The dive computer will not show times for ascent or
stops. However, all the other displays will function as before to provide
information for ascent. You should immediately ascend to a depth of 3
to 6 m [10 to 20 ft] and remain at this depth until air supply limitations
require you to surface.
After surfacing, you should not dive for a minimum of 48 hours. During
the permanent Error Mode, the Er text will be displayed in the center
window and the Planning Mode will be disabled.