Filter
Top Products
24
• the Personal Adjustment setting on the
left side of the center window with a
diver symbol and + signs (P0, P1, or
P2) (see Table 3.5.)
• the Diver Attention Symbol if attenuated
RGBM has been set (see Table 3.3.)
• blinking Diver Attention Symbol if
surface interval should be prolonged
(see Table 3.3.)
In addition with the optional wireless transmis-
sion enabled:
• the Remaining Air-time in the left
center window
• the cylinder pressure in bar [or psi]
displayed in the lower left corner
Alternative displays by pressing the TIME but-
ton (Fig. 3.9.):
• the current time, shown as TIME
• the water temperature in °C [°F]
NOTE! In Dive Mode the alternative display switch-
es back to the main display after 5 se conds.
3.3.2. Bookmark
It is possible to make special marks in the profi le
memory during a dive. These Bookmarks will be
shown as a dive log symbol when scrolling the
profi le memory on the computer display. The
Bookmarks will also be shown as annotations
in the PC-software, Suunto Dive Manager. To
make a bookmark on the profi le memory during
a dive press the PLAN button (Fig. 3.10.).
3.3.3. Cylinder Pressure Data
When using the optional wireless pressure
transmitter the pressure of your scuba cylinder
in bars [psi] will be shown digitally in the lower
left corner of the display Anytime you enter
into a dive, the remaining air time calculation
begins. After 30 - 60 seconds (sometimes
more, depending on your air consumption),
the fi rst estimation of remaining air time will be
Fig. 3.10. Bookmark
activation. An annotation,
Bookmark, is placed
in the profi le memory during
a dive by pressing PLAN
button. Note the Logbook
symbol.
Fig. 3.11. A three minute
Recommended Safety
Stop.
m
NO DEC TIME
T
C
B
MAX
DIVE TIME
bar
AIR
TIME
DIVE TIME
T
C
B
m
STOP
MAX
AIR
TIME
bar
Fig. 3.12. Cylinder pres-
sure warnings. Pressure
has dropped below 50 bar
[725 psi]. Pressure dis-
play is blinking and there
is an audible alarm.
m
NO DEC TIME
T
C
B
MAX
DIVE TIME
AIR
TIME
bar