Filter
Top Products
10. Attach a 3 1/2" "U" Bracket (98) to the left
Arm (51) with a 5/16" x 2 1/2" Bolt (20), 3/8"
Washer (8) and 5/16" Nylock Nut (4). Do not
overtighten the Nylock Nut--the "U" Bracket
must be able to pivot freely.
Attach a Thin "L" Bracket (99) to the 3 1/2"
"U" Bracket (98) with a 5/16" x 2 1/4" Bolt
(14) and 5/16" Nylock Nut (4). Make sure that
the Thin "L" Bracket is turned as shown. Do
not overtighten the Nylock Nut--the Thin "L"
Bracket must be able to pivot freely.
Attach a 3 1/2" "U" Bracket (98) and Thin "L"
Bracket (99) to the right Butterfly Arm (51) in
the same manner.
11. Press two 1 3/4" x 1 3/4" Inner Caps (28) into
the Leg Press Frame (72).
Attach the Leg Press Frame (72) to the Base
(69) with a 3/8" x 2 3/4" Bolt (16) and 3/8"
Nylock Nut (15).
Press a 2" x 2" Inner Cap (29) into the Base
(69).
12. Attach the Leg Lever (71) to the Leg Press
Frame (72) with a 5/16" x 2 3/4" Bolt (3) and
5/16" Nylock Nut (4).
Press a 1 1/2" x 1 1/2" Inner Cap (95) into the
Leg Lever (71). Attach the 1" Bumper (31) to
the Leg Lever with the 3/4" Screw (32).
Press a 3/4" Round Inner Cap (30) into each
end of a Pad Tube (66).
Insert the Pad Tube (66) into the lower end of
the Leg Lever (71). Center the Pad Tube and
slide a 6" Foam Pad (65) onto each end of it.
13. Apply grease to the pedal axles on the Rear
Upright (74).
Press two Pedal Bushings (39) into the Right
Pedal (64). Slide the Right Pedal onto the
right pedal axle. Note: Make sure that the
Pedal Is on the correct side--the slots
under the pedal must be oriented as shown.
Hold a 1 5/16" Retainer Ring (38) and 1"
Plastic Cap (37) against the end of the pedal
axle. Make sure that the teeth on the Retainer
Ring bend outward. Tap the Retainer Ring
and Plastic Cap onto the pedal axle.
Attach the Left Pedal (63) in the same manner.
10
11
The four holes I'/
must be on t;_ ///
, 15
29_ 16
12
Attach the Leg Lever
o 't- _ 7us=ng in=s hole
4--__ _ 31 / II L SJ
95 _ v 6"6 "_ _--30
13 J _
lots