Filter
Top Products
10
22. Attach the Backrest (78) to the Front Upright
(76) with two 1/4" x 2 1/2" Screws (2) and
1/4" Washers (1).
23.
Insert a 3/8" x 2 3/4" Bolt (16) into one side of
the Top Brace (86). Slide a 3/8" x 3/8" Metal
Spacer (6) onto the Bolt. Lay the ball-end of
the Short Cable (94) over a 3 1/2"Pulley (55).
Slide the Pulley and another 3/8" x 3/8" Metal
Spacer (6) onto the Bolt. Insert the Bolt
through the other side of the Top Brace and
tighten a 3/8" Nylock Nut (15) onto the Bolt.
Attach the 2" Metal Spacer (49) inside the
Top Brace (86) with a 5/16" x 2 3/4" Bolt (3)
and 5/16" Nylock Nut (4). Make sure that the
Short Cable (94) is under the 2" Metal Spacer.
24.
Insert the other end of the Short Cable (94)
(86) and the Front Upright (76). Lay the Cable
over a 3 1/2" Pulley (55). Hold the Pulley in
the upper end of the Front Upright.
Slide a 3/8" Washer (8) and 3/8" x 3/8" Metal
Spacer (6) onto a 3/8" x 3 1/2" Bolt (5). Insert
the Bolt through the Top Brace (86), Front
Upright (76) and 3 1/2" Pulley (55). Slide
another 3/8_x 3/8" Metal Spacer (6) and 3/8"
Washer (8) onto the Bolt and tighten a 3/8"
Jam Nut (7) onto the Bolt.
Tighten all Nylock Nuts used in assembly
steps 4-5.
25. Attach two.3 1/2" Pulleys (55) to the two "1'
Plates (75) with 3/8" x 1 3/4" Bolts (26) and
3/8" Nylock Nuts (15). Make sure that the
Pulleys are attached to the holes in the ends
of the "1" Plates.
22
23
15 86
6 "_" 3
94
24 r,,
0 ,J,J \
7_ ........... ,,
, \
r
25
15
75
55
55
,26
75