Filter
Top Products
8. 8
g.
Press two 1 3/4" x 1 3/4" Inner Caps (28) into
each of the Arms (51).
Apply grease to the axles On the Arm Support
(85). Slide an Arm (51) onto the right axle.
Hold two 1 5/16" Retainer Rings (38) and a
1" Plastic Cap (37) against the lower end of
the axle. Make sure that the teeth on the
Retainer Rings bend downward. Tap the Re-
tainer Rings and Plastic Cap onto the axle.
Attach the other Arm (51) in the same manner.
Wet the lower ends of the Arms (51) and the
insides of the two 6 1/2" Foam Pads (84) with
soapy water. Slide the Foam Pads onto the
Arms until the Foam Pads are 3" from the
lower ends.
Insert the end of a Handle (52) that has a
,_u_ th_ou it ;-'- tl-Ju -;-'-" ^'- _).
II tLU _._II U t;;;
II_IIL t"_1 III _=;.,_
5/16" Washer (10) and 5/16" x 3/8" Metal
Spacer (13) onto a 5/16" x 2 1/4" Bolt (14).
Insert the Bolt through the Arm and the
Handle. Slide another 5/16" Washer (10) onto
the Bolt and tighten a 5/16" Nylock Nut (4)
onto the Bolt.
Press a 1" Round Inner Cap (11) into the
Handle (52).- ....
Assemble a Handle (52) to the left Arm (51)
in the same manner.
Wet the Handles (52) with soapy water and
slide a Handle Grip (53) onto each Handle.
53
14
28
51