Filter
Top Products
49. Remove the "TRIAD LEG SYSTEM" decal
from the Decal Sheet (not shown). Apply the
decal to the corner of the Leg Press Plate
(70).
50. Remove the ten small decals numbered "10"
through "100" from the Decal Sheet (not
shown). Apply the decals to the ten Weights
(79) in the indicated locations. The decal
numbered "10" should be applied to the top
Weight; the decal numbered "100" should be
applied to the bottom Weight.
51. Remove the "INDEPENDENT ACTION
shown). Apply the decal to the Rear Upright
(74). The lower end of the decal should be
aligned with the cylinder axles.
Remove the "HOT" decal from the Decal
Sheet (not shown). Apply the decal to the
Rear Upright (74) above the indicated 5/16"
Nytock Nut (4).
Remove the two "SPEED LINK" decals from
the Decal Sheet (not shown). Apply the
decals to the Left and Right Pedals (63, 64).
Make sure that both decals are turned so the
words "FAST" are toward the Upright (74).
49
50
51
"TRIAD LEG SYSTEM"
"INDEPENDENTACTION
STEPPER"
Cylinder Axles
"SPEED LINK"
Note: The words
"FAST" must be
at this end.
64
17