Filter
Top Products
33. Attach a Thick "L" Bracket (100) to the bracket
on the Top Brace (86) with a 5/16" x 3 1/4"
Bolt (19) and 5/16' Nylock Nut (4). Make sure
that the Thick "L" Bracket is turned as shown.
Slide a Plastic Cable Guide (18) and a 3 1/2"
Pulley (55) onto a 3/8" x I 3/4" Bolt (26). Insert
the Bolt into the Thick "L" Bracket (100) and
tighten a 3/8" Nylock Nut (15) onto the Bolt.
Pull back the Plastic Cable Guide (18) and
lay the Long Cable (93) over the 3 1/2" Pulley
(55). Turn the Plastic Cable Guide so it holds
the Cable on the Pulley.
34. Slide a Plastic Cable Guide (18) and a 3 1/2"
Pulley (55) onto a 3/8" x 2" Bolt (44). Insert the
Bolt into the Thin "L" Bracket (99) on the left
Arm (51) and tighten a 3/8" Nylock Nut (15)
onto the Bolt.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) around the 3 1/2"
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley.
35. Attach a 3" "U" Bracket (97) to the Front
Upright (76) with a 5/16' x 4" Bolt (27), 5/16"
Washer (10) and 5/16' Nylock Nut (4). The
Nylock Nut should be threaded onto the
Bolt four complete turns. The cabling will
be too short If the Nylock Nut Is overtlght-
ened.
Wrap the Long Cable (93) around a 4 1/2"
Pulley (54). Attach the Pulley to the 3" "U"
Bracket (97) with a 3/8" x 1 3/4" Bolt (26) and
3/8" Nylock Nut (15).
36. Slide a Plastic Cable Guide (18) and a 3 1/2"
Pulley (55) onto a 3/8" x 2" Bolt (44). Insert the
Bolt into the Thin "L" Bracket (99) on the right
Arm (51) and tighten a 3/8" Nylock Nut (15)
onto the Bolt. Note: Make sure that the
3 1/2" Pulley is attached on the side of the
Thin "L" Bracket as shown.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) around the 3 1/2"
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley,
33
34
35
55
93
36
54 97.
93
\
15 99 _93
\
\
\
\
\
\
13