Filter
Top Products
29. 29
12
Attach a 3" "U" Bracket (97) to the Front
Upright (76) with a 5/16" x 4" Bolt (27), 5/16"
Washer (10) and 5/16" Nylock Nut (4). The
Nylock Nut should be threaded onto the
Bolt four complete turns. The cabling will
be too short If the Nylock Nut Is overtlght-
ened.
Wrap the Long Cable (93) around a 4 1/2"
Pulley (54) as shown. Attach the Pulley to the
3" "U" Bracket (97) with a 3/8" x 1 3/4" Bolt
(26) and 3/8" Nylock Nut (15).
30. Slide a Plastic Cable Guide (18) and a 3 1/2"
Pulley (55) onto a 3/8" x 3 1/2" Bolt (5). Insert
the Bolt into the Leg Lever (71). Slide a 3/8"
Washer (8) onto the Bolt and tighten a 3/8"
Nylock Nut (15) onto the Bolt.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) around the 3 1/3"
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley.
31.
Slide a Plastic Cable Guide (18) and a 3 1/2"
Pulley (55) onto a 3/8" x 3 3/4" Bolt (21).
Insert the Bolt into the tube on the Base (69)
and tighten a 3/8" Nylock Nut (15) onto the
Bolt.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) under the 3 1/3"
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley.
32.
Route the Long Cable (93) over the 3 1/2"
Pulley (55) at the lower end of the "1" Plates
(75).
Slide a Plastic Cable Guide (18) and a 3 1/2"
Pulley (55) onto a 3/8" x 3 3/4" Bolt (21).
Insert the Bolt into the tube on the Front
Upright (76) and tighten a 3/8" Nylock Nut
(15) onto the Bolt.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) under the 3 1/3"
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley.
3O
93
26
31
18
55
21 69
15