Filter
Top Products
o
.
,
.
Slide the Front Upright (76) over the two
5/16" x 2 1/2" Carriage Bolts (22) in the Base
(69). Attach the Front Upright with two 5/16"
Nylock Nuts (4). Do not fully tighten the
Nylock Nuts until completeing step 24.
Place the Top Brace (86) on top of the Front
and Rear Uprights (76, 74). Attach the brack-
et on the Top Brace to the Front Updght with
a 5/16" x 2 3/4" Bolt (3), 5/16" Washer (10)
and 5/16" Nylock Nut (4). Do not fully tight-
en the Nylock Nuts until completeing step
24.
Attach the Top Brace (86) to the Rear Upright
(74) with two 5/16" x 2 3/4" Bolts (3) and
5/16" Nylock Nuts (4). Do not fully tighten
the Nylock Nuts until ¢ompletelng step 24.
Press a 1 3/4" x I 3/4" Inner Cap (28) into
3/4" Round Inner Cap (30) into each side of
the Arm Support.
Apply grease to the rod of the Arm Support (85).
Tum an Arm Support Bushing (92) so the
rounded groove is on top. Place the Arm
Support Bushing on top of the plate on the
Top Brace (86). Rest the rod of the Arm
Support (85) in the rounded groove in the
Arm Support Bushing.
Place the other Arm Support Bushing (92) on
top of the rod of the Arm Support (85). Place
the Bushing Bracket (91) over the Arm
Support Bushings, Attach the Bushing
Bracket to the plate on the Top Brace (86)
with four 1/4" x 3/4" Screws (24) and 1/4"
Nylock Nuts (23).
4
5
6
7
86
24
23