Filter
Top Products
26. Route the end of the Short Cable (94) around
the indicated 3 1/2" Pulley (55) in the "t"
Plates (75).
Insert a 3/8" x 2 3/4" Bolt (16) into one side of
the Top Brace (86). Slide a 3/8" x 3/8" Metal
Spacer (6) onto the Bolt. Lay the Short Cable
(94) over a 3 1/2" Pulley (55). Slide the Pulley
and another 3/8" x 3/8" Metal Spacer (6) onto
the Bolt. Insert the Bolt through the other side
of the Top Brace and tighten a 3/8" Nylock Nut
(15) onto the Bolt.
27. Press the Domed Inner Cap (34) into the
lower end of the Weight Selector (82).
Slide a Weight (79) onto the upper end of the
Weight Selector (82). Make sure that the
Weight is turned so the pin groove is down-
ward.
Insert the end of the Short Cable (94) into the
upper end of the Weight Selector (82) and
attach it with the 5/16" x 1 1/2" Bolt (33) and
a 5/16" Nylock Nut (4).
28. Wrap the ball-end of the Long Cable (93)
under a 3 1/2" Pulley (55). Attach the Pulley
to the Leg Press Frame (72) with a 3/8" x
3 1/2" Bolt (5), 3/8" Washer (8) and 3/8"
Nylock Nut (15). Make sure that the Cable is
between the Pulley and the pin on the Leg
Press Frame.
26
27
28
86
15
/
Pin Groove
11