Filter
Top Products
61. Attach the end of the Leg Press Cable (69) tothe
"U"-bracket (50) withan M8 Washer (117) and an
M8 Nylon Locknut(115). Note: Do not complete-
ly tighten the Locknut; it should be tightened
so that only two threads of the Cable show
past the Locknut, as shown in the inset draw-
ing.
Seat Assembly
62. Attach the Seat (29) with the serial number decal
on the bottomto the Right Seat Frame (9) with
four M6 x 16mm Screws (85).
Repeat this step with the other Seat (29) and
the Left Seat Frame (not shown).
63. Attach a Backrest (28) to the Right Upright (4)
with four M6 x 16mm Screws (65).
64. Attach a Backrest (28) to the Backrest Frame (27)
with four M6 x 16mm Screws (85).
Slide the Backrest Frame (27) intothe Left
Upright (5). Engage the Knob (121) intothe
Upright and Backrest Frame, and turn itclockwise
untilit istight.
62
63
64
29
121
I I_bU
I r 115
I
27
21