Filter
Top Products
41. Wrap the Leg Lever Cable (70) undera 90mm
Pulley (39). Attach the Pulley and two Half Finger
Guards (42) tothe Right Base (1) with an M10 x
48mm Bolt(101) and an M10 Nylon Locknut
(114). Make sure the Finger Guards are orient-
ed as shown.
42. Wrap the Leg Lever Cable (70) over a 90mm
Pulley(39). Attach the Pulley,a Small Cable Trap
(48), and two Half FingerGuards (42) at the sec-
ond hole from the bottomof the two Pulley Plates
(51) with an M10 x 52mm Bolt (102) and an M10
Nylon Locknut(114). Make sure the Cable Trap
and Finger Guards are oriented as shown.
43. Wrap the Leg Lever Cable (70) undera 90mm
Pulley (39). Attach the Pulley and two Half Finger
Guards (42) tothe =U"-bracket on the RightBase
(1) with an MI0 x 48mm Bolt(101) and an M10
Nylon Locknut (114). Make sure the Finger
Guards are oriented as shown and are on the
outside of the "U"-bracket.
44. Wrap the Leg Lever Cable (70) under a 90mm
Pulley(39). Attach the Pulley, a Small Cable Trap
(48), and two Half Finger Guards (42) to the
bracket on the Right Base (1) with an MI0 x
52mm Bolt (102) and an M10 Nylon Locknut
(114). Make sure the Cable Trap and Finger
Guards are oriented as shown and that the
bracket is between the Pulley and the Finger
Guard next to the Locknut.
41
//
114
1 39
42
42
7O
45. Route the Leg Lever Cable (70) up throughthe
RightTop Frame (7), over a115mm Pulley (41),
and back down throughthe Top Frame. Attach
the Pulley insidethe Top Frame with an M10 x
80mm Bolt(111), two M10 Washers (116), two
19mm Spacers (77), and an M10 Nylon Locknut
(114).
45
17