Filter
Top Products
10. Identifythe Front Weight Guides (136), which
have the lockholes closerto the center than the
Rear Weight Guides (24). Orient the Weight
Guides with the holes closerto the bottom.
Attachthe Front Weight Guides (136) to the Right
Base (1) with an M10 x 155mm Bolt (130), two
M10 Washers (116), and an M10 Nylon Locknut
(114).
Slide two Weight Bumpers (65) ontothe Front
Weight Guides (136). Slide the ten Weights (35),
withthe pin holeson the indicatedside, ontothe
Weight Guides.
Press a Weight Tube Bumper (66) intothe Long
Weight Tube (36). Insertthe Weight Tube intothe
stack of Weights (35). Make sure the pin on the
Weight Tube sits in the groove on the top
Weight.
Grease the indicatedholes in a TopWeight (34)
withan included grease pack. Slide the Top
Weight onto the Front Weight Guides (136).
Repeat this step with the Rear Weight Guides
(24) and eight Weights (35).
11. Attach the RightTop Frame (7) to the Right
Upright (4) with two M8 x 80mm Bolts(94), two
M8 Washers (117), and two M8 Nylon Locknuts
(115). Do not tighten the Locknuts yet.
Attach the Right Top Frame (7) tothe Left Top
Frame (8) with two M8 x 60mm Bolts(94), two
M8 Washers (117), and two M8 Nylon Locknuts
(115). Do not tighten the Locknuts yet.
10
136
Lock
Holes
\
L
24
11
7
115
130
116
115
114
9