Filter
Top Products
19. Attach the Leg Bumper (76) tothe Right Seat
Frame (9) withan M4 x 16mm Self-tapping Screw
(113) and an M4 Washer (131).
Grease an M10 x 75mm Bolt (104). Attach the
Leg Lever (11) to the Right Seat Frame (9) with
the Boltand an M10 Nylon Locknut(114). Make
sure the "U"-rod is on the indicated side of
the Leg Lever. Do not over tighten the
Locknut; the Leg Lever must be able to pivot
easily.
20. Hold the Dip Assist(21) aroundthe Rear Upright
(6) and Left Upright (5) as shown. Make sure the
Dip Assist is under the indicated rod.
Attach the Cross Brace (64) to the Dip Assist (21)
with an M10 x 232mm Bolt(108), two M10
Washers (116), and an M10 Nylon Locknut (114).
Grease an M10 x 232mm bolt(108). Attachthe
DipAssist (21) to the Left Upright (5) with the Bolt
and an M10 Nylon Locknut(114). Do not over-
tighten the Locknut; the Dip Assist must be
able to pivot easily.
Attach the DipAssist Latch (67) to the DipAssist
(21) with an M10 x 85mm Bolt (107), two M10
Washers (116), a 12mm Spacer (75), and an Mt0
Nylon Locknut(114). Do not overtighten the
Locknut; the Dip Assist Latch must be able to
pivot easily. Engage the Latch over the rod on
the Rear Upright (6).
21. Wet the lowerend of the LeftButterflyArm (18)
withsoapy water. Slide a Large Foam Pad (79)
ontothe ButterflyArm,
Note: an entire grease packet should be used
for this step. Grease an M10 x 89ram Bolt(92)
and the indicatededges oftwo Arm Bushings
(59). Attach the Left ButterflyArm (18) to the
ButterflyFrame (22) with the Bolt, an M10 Large
Washer (134), the two Arm Bushings,and an
M10 Nylon Locknut (114). Make sure the bolt
head fits inside the hole in the Butterfly
Frame.
Repeat this step with the Right Butterfly Arm
(17).
19
114
11
20
21
l
59r_ase__ 79-_
12