Filter
Top Products
C846i/C842i Recumbent Cycle Assembly Guide 4
Rest the seat pad against the seat frame posts. Insert the four
buttonhead screws (C) and finger tighten.
CAUTION: It is critical that you use your fingers to thread the
four buttonhead screws before alternately tightening them
with the hex key (F). The nut inserts on the back of the seat
pad can be easily stripped by improper assembly, which is
not covered by the Precor Limited Warranty.
When the four buttonhead screws (C) are properly threaded,
alternately wrench tighten each screw using a hex key.
Sit on the seat to adjust it. Pull up on the seat adjustment handle and
use your legs to slide the seat along the center post.
Note: If the seat rocks from side to side, you will need to realign the
center wheel that runs inside the center post. Refer to the
instructions in the Product Owner’s Manual.
Seat adjustment
handle