Cateye EC-T220 Treadmill User Manual


 
9
4
Attach the control unit base to the handle masts.
Position the control unit cross to the handle masts, and then pre-
pare to pass the cords through the handle mast inside.
Caution: Be careful that the control unit does not fall down.
Remove the wire (lower side) which is wrapped around the
handle mast.
Through the lower opening, pull the wire which comes from
the handle mast inside, and draw the 3 cords from the inside.
Caution: Do not pull the wire forcefully. Pull the cords gradu-
ally while the cords are sending from the upper part of
the handle mast.
Fit the control unit onto the handle masts and fix it using the 4
bolt As.
Caution: Be sure that the cords are not pinched when installing
the control unit base onto the handle masts.
Control unit
Cords
Bolt A
Handle mast
1
2
3
5
Attach the connectors on the 3 cord ends to the
circuit board inside the main body.
Connector (white) : 1
Connector (big) : 3
Connector (small) : 2
Caution: The shape of the connectors on each of the 3 cords is
different. Be sure to connect each of them to the cor-
rect place.
Circuit board inside main body
Cord
E
C
-T
2
2
0
6
Attach the motor cover.
Remove the 4 screws, put the motor cover in position, and replace
the 4 screws to fix it in place.
Screw
Motor cover
Circuit board
Cords