Filter
Top Products
8
EC-T220
1
Remove the motor cover.
• The motor cover must be removed for assembly.
2
Attach the handle masts and handle.
• Insert the handle into the sides of the handle masts. Fix in place by
screwing in the 2 bolts (B) from above.
Caution: •Be sure which handle mast is the left one and which
is the right one before inserting the handle.
•Tighten the screws loosely at first. After the handle
masts, handle, and main body are assembled to-
gether, firmly tighten all the screws.
• Stand the handle masts up on the main body and fix them in place
with the six bolts (A).
Motor cover
Bolt B
Wire
Handle
Handle mast
Wire
Bolt A
Bolt A
3
Put the cords through the handle mast.
• Remove the wire (upper side) which is wrapped around the handle
mast.
• Wrap the same wire around the ends of the cords which come from
the control unit.
• Insert the 3 cords with the wire wrapped around into the handle
mast inside.
Cords
Handle mast
Wire